AP Supplies Water Butt Connector Kit 1.25in BSP, 2m 32mm Hose, 2 Clips | 1.25in BSP tank fittings (41.9mm thread) need a hole of about 43mm. For 25mm hose and a 34mm hole, choose the 1in size

Description

• Will it fit: Each tank fitting has a 1.25in BSP male thread, 41.9mm across, so it needs a hole of about 43mm, low down in a smooth, flat part of the butt wall. You need to reach inside the butt to fit the back nut. It will not fit a 3/4in or 1in tap hole
• What is in the kit: 2m of 32mm bore corrugated PVC hose, two straight tank fittings (1.25in BSP male thread to 1.25in hose barb), two washers, two back nuts and two double-wire hose clips. A drill bit is not included
• Can I cut the hose: Yes. The ribbed PVC hose cuts to length with a sharp knife, bends around sheds and walls, and is UV resistant, which helps limit algae growth inside
• How does it fit: Push each fitting through the tank wall, add the washer and tighten the back nut on the inside, then push the hose over the barbs and tighten a hose clip over each joint. Fit both at the same low height
• Which size do I need: Choose this 1.25in kit for 32mm hose or an existing 1.25in BSP outlet. For 25mm hose and a 34mm hole choose our 1in kit; for 40mm hose, our 1.5in kit