AP Supplies Water Butt Connector Kit 1in BSP, 2m of 25mm Hose, 2 Clips | Needs a 34mm hole per butt: two 1in BSP tank fittings (33.25mm thread), 2m hose, washers, back nuts and 2 clips

Description

• Will it fit: Each tank fitting has a 1in BSP male thread, 33.25mm across, and needs a 34mm hole drilled low down in a smooth, flat part of the butt wall. Reach inside to fit the back nut. Our 3/4in kit uses a 27mm hole
• What is in the kit: 2m of 25mm bore corrugated PVC hose, two straight tank fittings (1in BSP male thread to 1in hose barb), two washers, two back nuts and two double-wire hose clips. A drill bit is not included
• Can I cut the hose: Yes. The ribbed PVC hose cuts to length with a sharp knife and bends around corners. Push it over each barb and tighten a clip over the joint
• How does it fit: Push each fitting through the tank wall, add the washer and tighten the back nut on the inside, then push the hose over the barbs and tighten a hose clip over each joint, fitting both at the same low height so the levels balance
• Which kit do I need: Match the fitting to the hole or outlet on your butt. This kit is for 1in BSP; our 1/2in, 3/4in, 1.25in, 1.5in and 2in kits suit other butts